Does James Hardie make a fascia board?
Fiber Cement House Trim & Fascia | HardieTrim Boards | James Hardie.
Is Hardie discontinuing trim?
In August of 2021, suppliers and contractors were notified that James Hardie Building Products is intending to permanently stop manufacturing all Hardie Trim products for select markets.
Does Hardie make trim?
About Hardie® Trim Boards Accentuate corners, columns, friezes, doors, windows and more.
Can you use cement board for fascia?
We used fiber cement board to close in the soffits and cover the fascia of the house. Any rotted fascia boards should be replaced prior to covering.
What widths does Hardie trim come in?
Available in commonly-used nominal widths from 101mm (4 in) to 304mm (12 in). HARDIETRIM® BATTEN BOARDS HardieTrim® Batten Boards are a decorative non-load bearing trim product. HardieTrim® Batten Boards are 19mm (¾ in) thick, 64mm (2½ in) wide, and come on 3,658mm (12 ft) lengths.
Can you Miter Hardie board trim?
Attach the trim boards and Flat Tabs around the opening as shown in Figures 8.7 and 8.8. A flashing is required over the trim and Flat Tabs. (Figure 8.10) Terminate ends of the Band Board into Trim or Siding or miter cut the edges of the trim at the corners of the building.
What happened with James Hardie?
In 2021, James Hardie was vindicated after a New Zealand court dismissed a lawsuit claiming Harditex cladding caused weathertightness problems in New Zealand homes. The judge found that bad building methods rather than James Hardie products caused the problems.
What sizes does Hardie trim come in?
How do you cut Hardie board trim?
When it comes to cutting these products, the process is the same for both the trim and the siding.
- Install the HardiBlade saw blade in the saw.
- Measure the area where the trim piece will go.
- Mark the piece of trim to cut.
- Place the trim in the saw and adjust the saw to create the proper angle for the desired cut.
What size Hardie trim for corners?
Inside corners can be made with either a single HardieTrim 5/4, 4/4 board in the corner, or with one board on each wall depending on the desired look. Keep weather cuts at least 12 in.
Can you use Hardie trim on fascia?
FASCIA HardieTrim board is a decoratie non-load bearing trim roduct. Do not use HardieTrim to relace an structural comonent. HardieTrimboards can be fastened directly over a 2x sub-fascia or directly to rather tails.
Can you use Hardie trim board on structural components?
HardieTrim board is a decoratie non-load bearing trim roduct. Do not use HardieTrim to relace an structural comonent. HardieTrimboards can be fastened directly over a 2x sub-fascia or directly to rather tails. Check local building code for relevant codes.
What can I do with James Hardie trim?
Add that final flourish to your design statement. USE IT FOR: Trim provides a great way to introduce colors, whether contrasting your primary house color, or using a darker or lighter shade. The Insite technical service platform makes it easier and faster than ever to specify and build with James Hardie.
How do you install Hardie Hardie trim around corners?
HardieTrim®boards are installed around corners by pre-building the corner off the wall with the Corner Tabs (JH sku no. 280155). • Attach Corner Tabs to the back side of the trim with 8 18 ga. 1/2 in. L x 1/4 in W narrow crown corrosion resistant staples using a pneumatic staple gun.