How do you adjust the valves on a Briggs and Stratton engine?
How to Adjust Overhead Valves
- Step 1: Release the brake spring.
- Step 2: Insert a narrow screwdriver into the spark plug hole and touch the piston.
- Step 3: Check the valve clearance by placing a feeler gauge between the valve head and the rocker arm.
- Step 4: Adjust the clearances as required by turning the rocker screw.
Where to buy Briggs and Stratton parts?
Check Your Manual for specs on your engine. Either use your issued manual or look up your manual on our website.
What is the gap on Briggs Stratton?
Briggs & Stratton recommends that the air gap setting for the armature be set at 0.010-0.014 inches, or 0.25-0.36 mm; the spark plug gap should be set at 0.030 inches, or 0.76 mm. Valve clearance, with valve springs installed and piston 1/4-inch or 6 mm past top dead center, is intake valve set at 0.005-05007 inches, or 0.13 – 0.18 mm, and exhaust valve set at 0.009-0.011 inches, or 0.23-0.28 mm. Make sure that the engine is cold when you measure the valve clearance.
How to tune Briggs and Stratton engine?
Tune Up in Four Easy Steps. Step 1: Change the air filter. Briggs & Stratton engines use one of three types of air filters: foam, paper and a combination of foam and paper. Click on the type of filter you have for how-to’s on making the switch. Step 2: Change the oil.
What is the coil gap on Briggs and Stratton?
Common armature gap ranges are .006 – .010″ and .010 – .014″. Armatures are often packaged with a shim to assist in setting the gap. Index cards of the proper thickness also work well. Unhook the spark plug wire and secure it, removing any batteries, if equipped. Remove the old ignition coil (armature) mounting screws.