What is the Boss ds1 Keeley Mod?
This mod gives you 2nd order harmonic distortion, which has a very musical sound. At very high saturation levels it almost becomes an octave type of effect. DS-1 Ultra Distortion Pedal has been modified to have the Seeing Eye LED.
What Guitarrs use BOSS sd1?
The SD-1 certainly impressed more than a few guitar heroes. Notable users include Eddie Van Halen, Steve Vai, Zakk Wylde, John 5, Mark Knopfler, Josh Homme, Richie Sambora, Reb Beach, and Warren DeMartini.
Does a Boss DS1 have a buffer?
The Boss DS1 circuit can be broken down into 5 big blocks: Input Stage, Transistor Booster, Op-Amp Gain Stage, Tone Control, Output Buffer and Power Supply. The design idea is simple: The Input and Output Buffers will isolate the circuit, keeping the signal path clean and tone-sucking free.
Is Boss DS1 analog?
Our DS-1/Super mod was designed by Ohbayashi San (CAMTAC) and fine-tuned by Analog Mike. It replaces many of the cheap components that Boss uses (in order to make the stock pedal a super deal for the price) with expensive, high grade audio parts.
Is BOSS DS 1 analog?
Who used tube screamer?
Which notable guitarists have used Tube Screamers? “The most famous user would be the genius blues guitarist Stevie Ray Vaughan, who used the TS-808 and TS10 [and TS9].
How do I remove the knobs on the DS-1?
Use a flat head screwdriver to lever off the knobs on the DS-1 then use some pliers to unscrew the nuts on the pots. 2. Unscrew the black screws on either side to provide access to the on/off switch
Where do I put the Keeley switch on my Pedal?
My pedal has the Keeley switch on the front and two more switches on the side (one for circuit bending and the other for switching between two capacitors). If you want it on the front, be careful when drilling and make sure that you don’t damage the components!
How do I remove the DS-1 from the base plate?
Use a flat head screwdriver to lever off the knobs on the DS-1 then use some pliers to unscrew the nuts on the pots. 2. Unscrew the black screws on either side to provide access to the on/off switch 3. Unscrew the nuts on the input jacks 4. Undo all four screws on the base plate 5. Remove base plate, plastic to get to the circuit board. 6.