How do I activate my Harley Davidson alarm?

How do I activate my Harley Davidson alarm?

How do I activate my Harley Davidson alarm?

During a PIN disarm, if the smart security system detects motorcycle motion the system will activate the alarm. If necessary, verify the current 5-digit PIN. Turn Ignition key to IGNITION. Quickly (within 2 seconds of turning ignition key) hold both turn signal switches in until confirmation.

How does the Harley Davidson alarm system work?

When the motorcycle is parked and the ignition key is turned to off, the Harley-Davidson® Smart Security System arms automatically within five seconds if no motion is detected. Upon arming, the turn signals will flash twice and the optional siren will chirp twice.

How do I know if my Harley has a security system?

If your Harley Davidson bike has a security system, it will have an alarm and will come with a key fob. If you add the siren and pager, you might have two key fobs.

What is the trigger switch on Harley Davidson?

Vehicle off: Press the trigger switch (1) to display the accumulated mileage in the odometer. Hold trigger switch to turn on accessory mode. Vehicle in accessory/ignition mode: Press the trigger switch to cycle through the odometer functions.

Can you put an alarm system on a motorcycle?

However, you can go even further in to protect your ride by using a motorcycle alarm. Bike alarms typically are one of two varieties. The less-expensive option is to combine the lock and alarm into one noise-making security device.

What is the red key light on my Harley?

Registered. If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car.

What does the red key light mean on a Harley?

Only show this user. If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car.

Can you start a Harley without a key fob?

STARTING YOUR HARLEY-DAVIDSON WITHOUT YOUR FOB! Immediately hold both turn signal indicators until FIVE dashes appear in the odometer gauge. Select the first digit of your PIN (a) by pressing the left turn signal button (a) times. Press the right turn signal switch one time to move to the next digit.

How do I install the siren?

Slide the siren (2) into place on the back of the electrical bracket (1) so the sounder disc faces out. Be sure that the cables and conduit are properly routed so they are not pinched during assembly.

What kind of battery do I need for my siren?

When battery replacement is needed, only a nickel metal hydride (NiMH) 9 volt battery should be used in the siren. These are widely available at local battery outlets. Refer to POWER DISCONNECT in the owner’s manual and follow the instructions to prevent the security module from actuating the siren.

How do I replace the siren on my Softail?

Remove the right side saddlebag (if equipped) per the instructions in the owner’s manual. The siren connector is installed on an electrical panel under the rear fender on all Softail models. The rear of the motorcycle may have to be raised slightly to allow removal of the splash guard. 2. Remove the two bolts at the bottom of the splash guard.

How do I change the battery in my siren?

Open the battery cover by inserting a flat-blade screwdriver into one of the slots on the side of the siren box. Press until one corner of the cover pops up slightly. Insert the screwdriver into the second slot, and press until the cover pops open.